Percent Change vs Percentage Points: Explain the Difference in Ad Reports

A rate rising from 4% to 6% gains two percentage points and increases by 50% relative to its starting value. The first number describes the gap between rates; the second describes its size relative to the original rate. State which one you mean before using either in an advertising headline or budget review.
We show the counts, units and starting value beside the result. That lets the next reader distinguish more customers, a better rate and a change in the mix of visits.

Use percentage points for the gap between two rates
For percentage points, subtract the earlier rate from the later rate: 6% minus 4% gives a two-percentage-point increase. Writing “up 2%” would leave the reader unsure whether you mean that gap or a relative change.
Fictional example: the first group has 20 accepted enquiries from 500 eligible visits, giving 4%. The second has 30 from 500, giving 6%. There are ten additional accepted enquiries in these observed groups. The arithmetic describes the comparison; it does not establish which campaign change caused the difference.
Keep the visit and accepted-enquiry definitions the same in both groups. Changing from submitted forms to qualified enquiries changes the measure, even if the percentage calculation itself is correct.
Use percent change for the increase relative to the starting value
Relative percent change is the difference divided by the starting value, multiplied by 100. In the same example, (6 minus 4) divided by 4 is 0.5, or 50%. The accepted-enquiry count also rises by 50% because the two groups have the same 500-visit denominator.
A completed reporting line reads: “Accepted-enquiry rate: 4% to 6%; change: +2 percentage points, or +50% relative to the original rate. Counts: 20/500 to 30/500.” This states the same result without leaving “conversion up 50%” open to several interpretations.
For a cost that falls from $50 to $40, the relative decrease is $10 divided by $50: 20%. Dollar values do not have a percentage-point change. Keep the unit attached to the result instead of applying rate language to every metric.
Notice that reversing the comparison changes the percentage
Moving from 6% back to 4% loses two percentage points. The relative decrease is two divided by six, approximately 33.3%. A 50% increase followed by a 33.3% decrease can therefore return a rate to its starting level.
The denominator changes when you reverse the comparison. Use the new starting value, not the earlier growth figure. If the starting value is zero, the usual relative-change calculation divides by zero; show the actual starting and ending counts or rates instead of an ordinary growth percentage.
Combine the counts before calculating an overall rate
Now consider two separate fictional offer groups. Offer A produces ten accepted enquiries from 100 visits: 10%. Offer B produces 45 from 900: 5%. The combined rate is 55 enquiries divided by 1,000 visits, or 5.5%.
The simple average, 7.5%, gives equal weight to groups of 100 and 900 visits. The correct combined result uses 55/1,000 = 5.5%. Combine the counts only when they measure compatible actions and visits; otherwise keep the groups separate.
Our MER and ROAS scope guide addresses a related reporting boundary: two useful ratios can still use different revenue and cost bases. Correct arithmetic cannot repair a mismatched definition.
Explain a mix change before claiming every offer improved
In another fictional comparison, Offer A stays at a 20% accepted-enquiry rate and Offer B stays at 10%. Initially, each has 100 visits: 20 plus ten enquiries from 200 visits, or 15% overall.
Later, A has 200 visits and 40 enquiries, while B again has 100 visits and ten enquiries. The combined rate becomes 50 divided by 300, approximately 16.7%. Neither individual offer's rate improved. More of the observed visits went to the higher-rate offer.
The overall rise reflects a larger share of visits going to Offer A. It does not show an improvement within either offer, so the report should not credit both pages or both ads with better persuasion.
Finish with a report sentence that survives a handover
A completed note reads: “Overall accepted-enquiry rate: 15% to approximately 16.7%, about +1.7 percentage points. Offer rates stayed at 20% and 10%; visits shifted towards the higher-rate offer. Check the cost and qualified outcomes of that changed mix before expanding it.”
Use our monthly advertising review guide to carry the explanation into a spending decision. Our paid advertising agency services can help connect the figures with the business outcome they actually describe.
Comments